Logging Out Using an IC Card
Log out from the machine by waving your IC card over the machine when Quick Card Authentication is
specified.
• Wave only one IC card over the machine at a time.
1. Wave your IC card over the NFC card reader.
You will log out from the machine.
• You can also log out from the machine by pressing [Logout] in the top right corner of the screen.
Using a Smart Device to Log in to the MFP
When operating a machine for which user authentication is specified, you can log in to the machine
without entering a user name and password by holding your smart device near its operation panel.
For details about RICOH Smart Device Connector, see the manuals for RICOH Smart Device Connector.
• To use this function, enable the Quick Card Authentication function and Bluetooth Authentication
Plugin.
• Register the smart device to the MFP using the Quick Card Authentication function before using this
function.
• If the machine's Bluetooth setting is enabled and Quick Card Authentication is set to "Bluetooth",
you can log in to the machine by holding a smart device over the operation panel.
• To use a smart device, it is necessary to enable the Bluetooth setting and start RICOH Smart Device
Connector.
• The smart device's hardware and operating system must support Bluetooth Low Energy (BLE).
4. Getting Started
92
To Next Page
Loading...
