Updraft Fan Level
1302 [Main/2-Tray LCIT: Fan/Shutter] [Updraft Fan Level]
Function
Adjusts the amount of air blown to the leading edge to float up the paper.
When to use
If double-feeds do not improve by setting 1301: [Main/2-Tray LCIT: Paper Feed Mode] to
[Prevent Double Feed (Weakest Blow)], decrease the airflow in [Side Fan Level] in steps of 10%.
If paper misfeeds persist even after changing the air flow in 1301 [Main/2-Tray LCIT: Paper Feed
Mode] to [Prevent Non Feed (Strongest Blow)], try increasing the air flow in steps of 10% along
with the value for the side fan level.
Face curl Back curl
Sheets float up and tend to result in double-
feeds.
Sheets get pressed down and tend to result in
nonfeeds.
Blower Fan Level
1302 [Main/2-Tray LCIT: Fan/Shutter] [Blower Fan Level]
Function
Adjusts the amount of air blown between the top most sheet and the second sheet for separation.
When to use
If double-feeds do not improve by setting 1301: [Main/2-Tray LCIT: Paper Feed Mode] to
[Prevent Double Feed (Weakest Blow)], decrease the airflow in [Side Fan Level] in steps of 10%.
3. Details of Detailed Settings
44
To Next Page
Loading...
