* If double feed occurs at the start of the job, set a longer time for waiting.
Setting Item Max. Value Min. Value Step Unit
01: Paper Floating Wait Time 5 3 0.1 sec
Extend Fan Operating Time
Set to [On (Improve Separation)] for paper that is likely to double feed or not feed. Setting a longer fan
operating time improves separation. However, the paper feed interval is longer, which may lower
productivity.
Setting Item Values
02: Setting Off
On (Improve Separation)
Prevent Initial Nonfeed
Set to [On] for paper that is likely to not feed immediately after printing starts, but which is not improved
by setting [Prevent Non Feed] in [Paper Feed Mode: Fan Level]. Elevating the bottom plate of the tray
immediately after printing starts helps to prevent non-feeding.
Setting Item Values
03: Setting Off
On
Tray Elevation Assist
Set the timing at which tray elevation assist starts.
Setting Item Values
04: Assist Mode Off
Assist On When Remaining Paper Low
Always Assist On
Specify the thickness of paper (measured value) when you specify [Always Assist On] or [Assist On
When Remaining Paper Low] in [Assist Mode].
13: Machine: Paper Feed/Output
175
To Next Page
Loading...
