Ricoh Pro L5160 - Compensating the Clogged Nozzle Manually

1. Press the [Maintenance] key.
DWU102
2. Press [ ].
3. Press [Clogged Nozzle Settings].
4. Press [Auto Nozzle Check].
5. Press [Execute].
The nozzle check pattern is printed, and the clogged nozzle is detected.
6. Press [Confirm].
The clogged nozzle is registered.
7. Press [Nozzle Recovery].
8. Press [On].
The clogged nozzle is compensated with another nozzle. Prints with the compensated nozzle from
the first printing job after these settings are configured.
9. Press [Close].
10. Press [End].
• It is not reflected in the result of the test print even when [Nozzle Recovery] is set to [On]. When
checking the print result in which the clogged nozzle is recovered, print the recovery check pattern
by using the RIP software. For details about how to print, see "Functions on the Main Menu", RIP
Settings Guide.
Compensating the Clogged Nozzle Manually
After printing the nozzle check pattern, manually register a clogged nozzle. After registering a clogged
nozzle, make sure to enable [Nozzle Recovery].
1. Perform test printing to print the nozzle check pattern.
For details about test printing, see page 85 "Performing Test Printing".
3. Convenient Usage
116