1. Press the [Maintenance] key.
2. Press [ ].
3. Press [Clogged Nozzle Settings].
4. Press [Registering Clogged Nozzle].
5. Select the print head to be deleted.
6. Select the nozzle column to be deleted.
If you want to delete registration of nozzle A column of Head 1, select [H1-A Delete All].
7. Confirm the message on the control panel, and then press [Execute].
Registration of the clogged nozzle is deleted.
8. Press [Confirm].
9. Press [Close] 3 times.
10. Press [End].
Recovering the Clogged Nozzle by Compensating with Another Nozzle
119
To Next Page
Loading...
