Ricoh Ri 1000 - Page 207

207
Ri 1000 Replace Y Encoder Sensor Board
Introduction
This TD&R document is intended to aid RICOH Ri 1000 users in providing maintenance
and basic repair service. The information provided is intended to help with performing a
Y Encoder Sensor Board replacement. Accordingly this TD&R document is limited to
meet the objectives indicated above.
The majority of the hardware used in the RICOH Ri 1000 Direct to Garment printer is in
Metric series.
When performing maintenance on the machine, be sure to wear commercially available
goggles, gloves and a mask.
Scope
This applies to RICOH Ri 1000 printers.
Symptoms/ When To Change
1. PF motor error message appears
Supplies
Required supplies:
1. Y Encoder Sensor Board (J0175257)
2. #1 Phillips Head Screwdriver