RICOH Ri 1000/1000X Additional manual
9 / 15
8. Replacement Procedure of Type G2 White Ink
In case of KCMY＋W mode
In case of KCMY+W mode, please follow the procedure below to replace the ink with Type G2
White Ink.
STEP1. Replace the white ink to be changed with Type G2 White Ink (or
Type G2 White Ink (Hi Yield)).
Since one head is connected to one white cartridge, white ink can be replaced not
only by replacing two white cartridges at the same time, but also by replacing one
white cartridge at a time.
Ri 1000 : Head 2 is connected to W1 cartridge, Head 3 to W2 cartridge.
Ri 1000X: Head 2 is connected to W1A cartridge, Head 3 to W1B cartridge.
STEP2. Perform “Strong” head cleaning.
Perform a Strong cleaning on the head to which the cartridge replaced in Step 1 is
connected.
STEP3. Repeat STEP 2 (*Total of 5 Times Including STEP 2).
Perform “Strong” head cleaning a total of 5 times per head.
Reference: Operating time (Replacing all cartridges at the same time) 35-45 min.
Preparation: 10-20 min + Ink replacement (STEP2-3): 25 min
However, if frequent white ink non-discharge occurs after filling with Type G2 White Ink, please
clean the white ink path with a cleaning solution and then fill again with Type G2 White Ink. The
procedure for cleaning with the cleaning solution is as follows.
Remove white Ink cartridges.
Insert the cleaning cartridges designated for White channels.
To Next Page
Loading...
