EasyManua.ls Logo

Ricoh S-P2 - Page 112

Ricoh S-P2
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5828 069 JobSpool Protocl
This SP determines whether job spooling is enabled or disabled for each protocol. This is
a 8-bit setting.
0: LPR/ 1: FTP (Not Used)/ 2: IPP/ 3: SMB/ 4: BMLinks (Japan Only)/
5: DIPRINT/ 6: Reserved (Not Used)/ 7: Reserved (Not Used)
5828 090 TELNET
Disables or enables Telnet operation. If this SP is disabled, the
Telnet port is closed.
[0to1/1]
0: Disable
1: Enable
5828 091 Web
Disables or enables the Web operation.
[0to1/1]
0: Disable
1: Enable
5828 145 ActIPv6LinkLocal
This is the IPv6 local address referenced on the Ethernet or
wireless LAN (802.11b) in the format:
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8
blocks of 16 bits each. These notations can be abbreviated. See
"Note: IPV6 Addresses " below this table.
5828 147 ActIPv6Sttles1
These SPs are the IPv6 stateless addresses (1 to 5) referenced
on the Ethernet or wireless LAN (802.11b) in the format:
"Stateless Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8
blocks of 16 bits each.
5828 149 ActIPv6Sttles2
5828 151 ActIPv6Sttles3
5828 153 ActIPv6Sttles4
5828 155 ActIPv6Sttles5
5828 156 IPv6Manual Address
This SP is the IPv6 manually set address referenced on the
Ethernet or wireless LAN (802.11b) in the format:
"Manual Set Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8
blocks of 16 bits each. These notations can be abbreviated. See
"Note: IPV6 Addresses" below this table.
5. Service Tables
110
5

Table of Contents

Related product manuals