Initializes the hard disk and clears all data. Use this only if there is a hard disk error.
5837
Prog Checksum
Displays the checksum for the engine firmware.
5840 IEEE 802.11b
5840 006
Channel Max
Sets the maximum range of the bandwidth for the wireless LAN. This bandwidth setting
varies for different countries.
[1 to 11(NA) or 13 (EU)/11 (NA) or 13 (EU)]
5840 007
Channel Min
Sets the minimum range of the bandwidth for operation of the wireless LAN. This
bandwidth setting varies for different countries.
[1 to 11(NA) or 13 (EU)/1 (NA) or 1 (EU)]
5840 011
WEP key number
Determines how the initiator (SBP-2) handles subsequent login requests.
[00 to 11/00/1]
Note: There are four settings (binary numbers): 00, 01, 10, 11. These settings are possible
only after the wireless LAN card has been installed.
00: 1st key. If the initiator receives another login request while logging in, the request is
refused.
01, 10, 11: 2nd, 3rd, 4th keys are "Reserved".
5842
NFA analysis DFU Netfile Analysis
This is a debugging tool. It sets the
debugging output mode of each
Net File process.
Bit SW 0011 1111
Bit Groups
0 System & other groups (LSB)
1 Capture related
2 Certification related
3 Address book related
4 Machine management related
5. Service Tables
112
To Next Page
Loading...
