• However, only 10 bytes can be used to communicate with
the controller, so the 16 bytes are truncated to 10 bytes.
7931 012 Remaining Toner
Displays "0" to "100" (the percentage of toner remaining in the
cartridge)
7931 013 Toner End
N: Toner near end
E: Toner end
7931 014 Refill Flag Displays "RF" when the cartridge requires refilling
7931 015 R:Total Counter
Displays a number in the range "0" to "99999999", this is the
total count at time of installation.
7931 016 E:Total Counter
Displays a number in the range "0" to "99999999", this is the
total count at toner end.
7931 017 Unit Counter
Displays a number in the range "0" to "99999999", this is the
total number of pages output by the AIO unit. Counter adds once
for each sheet output.
7931 018 Install Date
Displays Year-Month-Date of installation for the AIO unit, this
setting updates automatically through a serial interface with the
machine when the new unit is installed.
7931 019 Toner End Date Displays Year-Month-Date when toner end occurred
7931 020 Conductor Time1 Displays a number in the range "0" to "00000000", this is the
count for OPC.
Note:
• This information resides at four locations (020, 021, 022,
023. The recycle count determines where the value is
written.
• The counter increments by "1" for every 6 sec. of drum
rotation time.
• To calculate the actual time in sec., multiply the displayed
value by 6.
7931 021 Conductor Time2
7931 022 Conductor Time3
7931 023 Conductor Time4
7932
CartRidge Life
Displays information about the cartridge service life.
• Returns a value of "0" if the number stored in the cartridge is not recognized.
Printer Engine Service Mode
133
To Next Page
Loading...
