Ricoh SP 200S - Page 25

7. Select the paper type and paper size, and then click [OK].
8. Click [Close].
Changing the custom paper size
1. On the [Start] menu, click [All Programs].
2. Click [Smart Organizing Monitor for SP xxx Series].
3. Click [Smart Organizing Monitor for SP xxx Series Status].
4. If the machine you are using is not selected, click [Select Device...], and then select the
machine's model.
5. Click [OK].
6. On the [User Tool] tab, click [Printer Configuration].
7. On the [System] tab, select [mm] or [inch] in the [Measurement Unit:] list.
To specify the bypass tray, click the [Copy] tab, and then select [mm] or [inch] in the [Measurement
Unit:] list.
8. In the [Horizontal: (100 to 216 mm)] box, enter the width.
To specify the size of custom paper loaded in the bypass tray, enter its width in the [Horizontal: (90
to 216 mm)] box.
9. In the [Vertical: (148 to 356 mm)] box, enter the length.
10. Click [OK].
11. Click [Close].
Loading Paper
23