Ricoh SP 200S - Error and Status Indicate on the Control Panel; Codes on the Screen

Error and Status Indicate on the Control Panel
Codes on the Screen
• If "C", "c", or "r" appears, contact your sales or service representative.
Code Causes Solutions
E0
A paper jam has occurred in the
machine.
Remove the jammed paper. See p.54 "Paper
Feed Problems".
E1 Tray 1 has run out of paper.
Load paper into Tray 1. See p.18 "Loading
Paper".
E2
The paper required for making copies,
printing jobs sent from the printer driver,
or printing manual reports is not loaded.
Load the appropriate size paper.
E3 The front cover or fusing cover is open.
Close the front cover or fusing cover
completely.
E4 The bypass tray has run out of paper.
Load paper into the bypass tray. See p.18
"Loading Paper".
E5
An appropriate size paper for printing
Report is not loaded.
Load the appropriate size paper.
E6
The print cartridge has not been
installed.
Reinstall the print cartridge. See p.47
"Replacing the Print Cartridge".
E7 The machine has run out of the toner.
Replace the print cartridge. See p.47
"Replacing the Print Cartridge".
E8 The print cartridge is almost empty. Prepare a new print cartridge.
E9
The paper for combine copy, duplex
copy or ID Card copy is not loaded.
Load A4 or Letter size paper.
e1 The waste toner bottle is full. Replace the print cartridge.
e2
If paper is loaded in the bypass tray
when printing with the paper fed from
Tray 1, you cannot print.
Remove the paper loaded in the bypass tray.
8. Troubleshooting
66