Error and Status Indicate on the Control Panel
Codes on the Screen
• If "C", "c", or "r" appears, contact your sales or service representative.
Code Causes Solutions
E0
A paper jam has occurred in the
machine.
Remove the jammed paper. See page 62
"Paper Feed Problems".
E1 Tray 1 has run out of paper.
Load paper into Tray 1. See page 22
"Loading Paper".
E3 The front cover or fusing cover is open.
Close the front cover or fusing cover
completely.
E4 The bypass tray has run out of paper.
Load paper into the bypass tray. See page 22
"Loading Paper".
E5
An appropriate size paper for printing
Report is not loaded.
Load the appropriate size paper.
E6
The print cartridge has not been
installed.
Reinstall the print cartridge. See page 55
"Replacing the Print Cartridge".
E7 The machine has run out of the toner.
Replace the print cartridge. See page 55
"Replacing the Print Cartridge".
E8 The print cartridge is almost empty. Prepare a new print cartridge.
E9
The paper for ID Card copy is not
loaded.
Load the appropriate size paper.
e2
If paper is loaded in the bypass tray
when printing with the paper fed from
Tray 1, you cannot print.
Remove the paper loaded in the bypass tray.
P1
The specified paper size of the file does
not match that of the paper loaded in
Tray 1.
Press the [Start] key to begin printing, or press
the [Stop/Clear] key to cancel the job.
8. Troubleshooting
74
To Next Page
Loading...
