Ricoh SP 230DNw - Page 59

2-45
Confidential
 Paper jam at the manual feed slot
<User Check>
• Check that the paper is set in the manual feed slot correctly.
• Flip over the paper in the manual feed slot or rotate the paper 180°.
• Adjust the paper guide according to the paper size.
• Check that multiple sheets of paper are not set.
• Check that the thickness of the paper is 60 to 230 g/m
2
.
Step Cause Remedy
1
Foreign object around the
manual feed slot
Remove the foreign object.
2
Connection failure of the
registration front/rear sensor
harness
Reconnect the registration front/rear
sensor harness.
3
T1 registration front actuator
coming off
Reattach the T1 registration front actuator.
4
Connection failure of the
registration clutch harness
Reconnect the registration clutch harness.
5
Registration front/rear sensor
failure
Replace the actuator holder ASSY.
6 Paper feed motor failure Replace the paper feed motor.
7
High-voltage power supply PCB
failure
Replace the high-voltage power supply
PCB ASSY.
8
Damaged gears in the paper
feed drive system
Replace the frame L unit.
9 Fuser unit failure Replace the fuser unit.
10 Main PCB failure Replace the main PCB ASSY.