3-36
Confidential
(3) Open the ADF unit. Release the Hook of the FFC holder ASSY, and remove the FFC
holder ASSY from the Document scanner unit.
(4) Lift the ADF unit, and remove the ADF unit from the Document scanner unit while pushing
the Hook of the Hinge R. Pull out the ADF sensor harness unit from the Hole.
(5) Remove the FFC holder ASSY from the ADF sensor harness unit.
Fig. 3-23
Harness routing: Refer to “2. ADF unit”.
Fig. 3-24
Assembling Note:
• If you replaced the ADF unit, refer to “5. IF YOU REPLACE THE ADF UNIT, CIS UNIT
OR DOCUMENT SCANNER UNIT” in Chapter 4 to configure settings.
• Attach the FFC holder ASSY to the ADF sensor harness unit as shown in the figure
below.
Hinge R
FFC holder ASSY
Hook
ADF unit
Hook
Document scanner unit
Hole
ADF sensor
harness unit
FFC holder ASSY
ADF sensor harness unit
To Next Page
Loading...
