Ricoh SP 230SFNw - Page 183

3-65
Confidential
(6) Remove the Taptite bind B M4x12 (6a) screw (for securing the Under bar), the Taptite cup
S M3x6 SR (6b) screw (for securing the Chute ground plate), the Taptite bind B M4x12 (6c)
screw (for securing the Registration chute), and the Taptite cup S M3x8 SR (6d) screw (for
securing the Laser L FG plate).
(7) Remove the two Taptite bind B M4x12 (7a) screws and the two Taptite cup S M3x8 SR (7b)
screws, and remove the Frame L unit. Pull out the Paper feed sensor harness and the
LVPS harness from the Holes.
Fig. 3-59
Harness routing: Refer to “10. Frame L unit”.
Assembling Note:
• When assembling the Frame L unit, make sure that the Chute ground plate is above
the Main PCB FG plate 2.
Taptite cup S M3x8 SR (6d)
Taptite cup S M3x8 SR (7b)
Taptite bind B
M4x12 (7a)
Frame L unit
Taptite bind B M4x12 (6c)
Registration chute
Taptite cup S M3x6 SR (6b)
Chute ground plate
Taptite bind B M4x12 (6a)
Under bar
Registration chute
7b
Laser L FG plate
6d
7a
7b
<Upper side of Frame L>
Main PCB FG
plate 2
Hole
Hole
Paper feed sensor
harness
LVPS
harness
Hole
Hole
<Bottom side>
<Overhead view
of Frame L>