5. Press the [Start] key.
Depending on the machine's settings, you may see the following screen on the display when
scanning from the exposure glass.
If you see this screen, proceed to the next step.
6. If you have more originals to scan, place the next original on the exposure glass, and
then press [Yes]. Repeat this step until all originals are scanned.
7. When all originals have been scanned, press [No] to start sending the scanned file.
• To cancel scanning, press the [Scanner] key, and then press the [Clear/Stop] key. The scan files
are discarded.
• You can also specify a destination using the One Touch buttons, [Pause/Redial] key (only SP
320SFN and SP 377SFNwX). For details, see page 119 "Specifying the Scan Destination Using
the One Touch Buttons or [Pause/Redial] Key (only SP 320SFN and SP 377SFNwX)".
5. Scanning Originals
118
To Next Page
Loading...
