1. Press the [Facsimile] key.
2. Place the original on the exposure glass or in the ADF.
To place the originals, see page 65 "Placing Originals".
3. Enter the fax number (up to 40 characters) using the number keys, or specify a
destination using the One Touch buttons or Speed Dial function.
For details about entering characters, see page 32 "Entering Characters".
For details about specifying destinations using the One Touch buttons or Speed Dial function, see
page 149 "Specifying the Fax Destination".
If the machine is connected to the telephone network through a PBX, make sure to enter the outside
line access number specified in [PBX Access Number] before the fax number. For [PBX Access
Number], see page 206 "Administrator Settings".
4. Press the [Start] key.
• Depending on the machine's settings, you may be prompted to enter the fax number again if
you manually entered the destination fax number. In this case, re-enter the number within 60
seconds, and then press the [Start] key. If the fax numbers do not match, go back to Step 3.
For [Fax Number Confirmation], see page 206 "Administrator Settings".
• When using the exposure glass in Memory Transmission mode, you will be prompted to place
another original. In this case, proceed to the next step.
Sending a Fax
147
To Next Page
Loading...
