Using Smart Organizing Monitor under the Macintosh Environment
10
TCP/IP
v IP Address
This device's network IP address. Enter it in the following format:
"xxx.xxx.xxx.xxx" (replace "x" with the appropriate numbers, for example:
"123.123.123.123").
v Subnet Mask
Specify the part of the IP address used as the subnet mask. Enter it in the fol-
lowing format: "xxx.xxx.xxx.xxx" (replace "x" with the appropriate numbers,
for example: "123.123.123.123").
v Default Gateway Address
Enter the default gateway address. The default gateway address is the IP ad-
dress of the host or router used as the gateway when communicating (print-
ing or exchanging information) with a computer on another network.
v DHCP
Select [On] to automatically configure the network settings using the DHCP
server. Select [Off] to configure the network settings manually.
If DHCP is active, all TCP/IP settings are obtained automatically from the
DHCP server.
v DNS Method
The default setting is [Auto]. When [Auto] is selected, the primary DNS server
IP address and the DNS domain name obtained from the DHCP server are
displayed.
If you select [Manual], you can manually specify the primary DNS server IP
address and the DNS domain name.
v Primary DNS Server IP
Enter the DNS Server IP address in the following format "xxx.xxx.xxx.xxx"
(replace "x" with the appropriate numbers, for example: "123.123.123.123")
When the DNS method is set to "Auto", you cannot manually specify the pri-
mary DNS server IP address.
v DNS Domain Name
Enter the domain name, using up to 32 alphanumeric characters.
When the DNS method is set to "Auto", you cannot manually specify the pri-
mary DNS domain name.
To Next Page
Loading...
