sending to. The original is not stored in memory. You can only specify one destination. If fax is
not received normally, an error message appears on the control panel.
Configuring the transmission mode
1. Press the [Facsimile] key, and then press the [ ] or [ ] key.
Alternatively, you can press the [Shortcut to Func.] key if [Shortcut to Function] under [Admin.
Tools] is set to [Direct Transmission]. For [Shortcut to Function], see page 206 "Administrator
Settings".
2. Press the [ ] or [ ] key to select [Direct Transmission], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Off], [On], or [Next Fax Only], and then press the
[OK] key.
For Memory Transmission, select [Off].
For Immediate Transmission, select [On] or [Next Fax Only].
4. Press the [User Tools] key to return to the initial screen.
Basic Operation for Sending a Fax
• The original in the ADF takes precedence over the original on the exposure glass if you place
originals both in the ADF and on the exposure glass.
• If you are using the SP 377SFNwX and the setting for [Original] is either [Dup.Portrait:T To T],
[Dup.Portrait:T To B], [Dup.Landscape:T To T], or [Dup.Landscape:T To B], load the originals into
the ADF. No data is transmitted if you place the originals on the exposure glass. For details about
the [Original] setting, see page 184 "Fax Features Settings".
6. Sending and Receiving a Fax
146
To Next Page
Loading...
