Message Causes Solutions
Check Paper Type The paper type set for the
document differs from the type
of the paper in the indicated
tray.
Press the [OK] key to begin printing, or
press the [Back] key to cancel the job.
Connection Failed The line could not be connected
correctly.
• Confirm that the telephone line is
properly connected to the machine.
• Disconnect the telephone line from
the machine, and connect a standard
telephone in its place. Confirm that
you can make calls using the
telephone. If you cannot make calls
this way, contact your telephone
company.
Cover open A cover is open. Close the cover completely.
Dest. is not
Programmed
No Quick Dial entry is
associated with the One Touch
button you pressed.
• Press a different One Touch button.
• Assign a registered destination to the
One Touch button. See page 95
"Registering Scan Destinations".
Dial Failed The fax could not be sent. • Confirm that the fax number you
dialed is correct.
• Confirm that the destination is a fax
machine.
• Confirm that the line is not busy.
• You may need to insert a pause
between dial digits. Press the [Pause/
Redial] key after, for example, the
area code.
Exceeded Max.E-
mail Size
The scan file exceeds the size
limit for files that can be sent
through e-mail.
• Configure [Resolution] under [Scan
Settings] to reduce the scanning
resolution. See page 181 "Scan
Settings".
• Configure [Max. E-mail Size] under
[Scan Settings] to increase the
allowed size. See page 181 "Scan
Settings".
Error and Status Messages on the Screen
273
To Next Page
Loading...
