Message Causes Solutions
Memory Overflow • The machine's memory
reached capacity while
scanning the first page of
the original to store a fax
job in memory before
transmission.
• The machine's memory
reached capacity while
storing a fax in memory in
Memory Transmission
mode.
Resend the fax in parts as several smaller
individual faxes, or send at a lower
resolution.
Memory Overflow
TX
Cancel
Memory has reached capacity
while scanning the second or
later pages of the original when
trying to send a fax in Memory
Transmission mode.
Press [TX] to send only the pages that have
been scanned in memory, or press
[Cancel] to cancel.
Misfeed: BypassTray Paper has been jammed in the
bypass tray.
Remove the jammed paper. See
page 281 "Clearing Misfeeds".
Misfeed: Dup. Unit
Remove Paper
Paper has been jammed in the
duplex unit.
Remove the jammed paper. See
page 281 "Clearing Misfeeds".
Misfeed: Stnd. Tray Paper has been jammed in the
paper exit area.
Remove the jammed paper. See
page 281 "Clearing Misfeeds".
Misfeed: Tray 1 Paper has been jammed in the
tray 1 paper input area.
Remove the jammed paper. See
page 281 "Clearing Misfeeds".
Net Communication
Error
Connection with the server was
lost while sending or receiving
data.
Contact the network administrator.
Network is not Ready A scanned file could not be sent
because the machine has not
received IP address information
from the DHCP server
completely.
Wait until the machine receives the IP
address information completely, and then
try the operation again.
On Hook or Stop key The machine has been off-hook
for an extended period of time.
Put down the handset phone or press the
[Clear/Stop] key.
Error and Status Messages on the Screen
275
To Next Page
Loading...
