Recommended size of originals
This section describes the recommended size of the original.
Exposure glass
Up to 216 mm (8.5 inches) in width, up to 297 mm (11.7 inches) in length
ADF (only SP 320SFN, SP 377SNwX, and SP 377SFNwX)
• Paper size: 140 to 216 mm (5
1
/
2
to 8
1
/
2
inches) in width, 140 to 356 mm (5
1
/
2
to 14
inches) in length
• Paper weight: 52 to 120 g/m
2
(13.8 to 28.0 lb.)
• Only 1 sheet of an original can be placed on the exposure glass at a time.
• In the ADF, up to 35 sheets of originals can be placed at once (when using paper weighing 80
g/m
2
, 20 lb.).
Types of originals not supported by the Auto Document Feeder (only SP 320SFN, SP
377SNwX, and SP 377SFNwX)
If placed in the ADF, the following types of original might be damaged or become jammed, or result in
gray or black lines appearing on prints:
• Originals larger or heavier than recommended
• Stapled or clipped originals
• Perforated or torn originals
• Curled, folded, or creased originals
• Pasted originals
• Originals with any kind of coating, such as thermal fax paper, art paper, aluminum foil, carbon
paper, or conductive paper
• Originals with perforated lines
• Originals with indexes, tags, or other projecting parts
• Sticky originals such as translucent paper
• Thin, highly flexible originals
• Thick originals such as postcards
• Bound originals such as books
• Transparent originals such as OHP transparencies or translucent paper
• Originals that are wet with toner or white out
Placing Originals
67
To Next Page
Loading...
