2
Getting Started
35
Initial Settings
Turn the camera on and make the initial settings.
Turning the Camera On
1 Press the power button.
The power button lamp turns on.
The first time the camera is turned on after
purchase, the [Language/H] screen ap-
pears.
When the power button is pressed again, the
power turns off.
Memo ---------------------------------------------------------------------------------------------------------
• When g is pressed and held with the camera turned off, the camera turns on in the playback mode.
The following operations are available.
• The power button lamp can be set to [Off] in [Power Button Lamp] of the E menu. (p.83)
• If no operations are made for about one minute (default setting), the camera turns off automatically
to suppress battery drain. The power saving function can be set in the E menu. (p.84)
• The display of the start-up screen can be set in [Start-up Screen] of the C menu. (p.82)
• You can also make settings so that the camera is turned on and off by pressing and holding the power
button to prevent misoperation. When [Power Button Hold Op.] is set to [On] in the E menu, press
and hold the power button for about 2 seconds to turn the camera on, and press and hold for about
5 seconds to turn the camera off.
To Next Page
Loading...
