What to do if my RIDGID Cut-off machines motor does not start?
If the motor of your RIDGID Cut-off machine doesn't start, here are a few things to check: * **Fuse:** Ensure you're using a 15 amp time delay fuse or circuit breaker. * **Brushes:** The brushes may be worn. * **Low Voltage:** Verify the power supply provides the correct voltage and adjust if necessary. If none of these steps work, seek authorized RIDGID service.
Why does my RIDGID Cut-off machines motor stall easily?
If your RIDGID Cut-off machine motor stalls easily, it could be due to a couple of reasons: * **Low Voltage:** Make sure your power supply is providing the correct voltage, and correct it if needed. * **Excessive Wheel Pressure:** Reduce the pressure. Pull the wheel through the workpiece at a slower pace.
How to fix a cut that is not square with RIDGID Cut-off machines?
If your RIDGID Cut-off machine is producing cuts that aren't square, consider these potential causes: * **Defective Wheel:** Replace the wheel immediately. * **Improper Work Positioning:** Ensure the workpiece is positioned correctly. * **Excessive Wheel Pressure:** Reduce the amount of pressure you're applying to the handle.
Why does my RIDGID Cut-off machines tool vibrate or shake?
If your RIDGID Cut-off machine is vibrating or shaking, consider the following: * **Wheel Condition:** The wheel might not be round or could be damaged, in which case, replace it. * **Loose Wheel:** Ensure the arbor screw is tightened. If the issue persists, seek authorized RIDGID service.
What to do if RIDGID Cut-off machines wheel binds or burns workpiece?
If the cut-off wheel of your RIDGID Cut-off machine binds, jams, burns the workpiece, or results in rough cuts, here’s what might be happening: * **Improper Wheel:** The wheel might not be right for the job. Replace it with a 14” diameter wheel designed for the material you're cutting. * **Dull Wheel:** The cut-off wheel might be dull; replace it.
What to do if power head won’t fully rise on RIDGID Cut-off machines?
If the power head of your RIDGID Cut-off machine won’t fully rise, or the lower guard won’t fully close, consider these possibilities: * **Dirt:** Inspect and clean any dirt sticking to the stops. If these steps don't resolve the issue, seek assistance from Authorized Service.
Detailed list of replacement parts with part numbers and descriptions.
Troubleshooting for motor-related issues like starting and stalling.
Covers common machine operation problems and cut quality.
Diagram showing the electrical connections for the machine.
General| Motor Power | 15 Amp |
|---|---|
| No Load Speed | 3800 RPM |
| Weight | 42 lbs |
| Arbor Size | 1 inch |
| Voltage | 120V |
| Power Source | Corded Electric |
| Blade Diameter | 14 inches |
| Cutting Capacity | 5 inches |
| Spindle Size | 1 inch |
To Next Page