EasyManuals Logo

RIDGID R6791 Quick Start Guide

RIDGID R6791
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
998000092
12-30-19 (REV:02)
WARNING: This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using
this product. All page references refer to the operator’s manual, where you can find detailed instructions for performing each step mentioned below.
DO NOT RETURN TO THE STORE!
If you have any questions, please call: 1-866-539-1710
or visit our website at www.ridgid.com
1
Change nosepiece, if necessary, and set desired
screw length. Retighten screw securely to make
sure nosepiece is secure. (See page 7)
R6791/R6791VN QUICK START GUIDE
2
D
A
B
A
C
B
D
A - Nosepiece screw
B - Adjustable nosepiece (drywall)
C - Adjustable nosepiece (wood)
D - Feed housing edge
A - Adjustable nosepiece (wood)
B - Feed housing
C - Bit
D - Bit load button
1
Install desired bit. (See page 6)
1
1
Verify screw tops are resting against collated
tape material as shown below, then load collated
screws into screwdriver. (See page 7)
3
A
B
A - Feed housing
B - Screw guard
C - Strip guide
D - Second empty hole aligned with bit
1
Adjust depth of drive, if needed. (See page 7)
4
4
7
C
A - Increase depth
B - Decrease depth
C - Depth of drive adjustment thumbwheel
A B
C
1
Set desired forward/reverse switch direction,
secure workpiece, and plug in screwdriver.
Depress switch trigger to start, THEN press
nosepiece against work surface with constant
force to drive screw. When bit stops rotating,
remove from work surface and proceed to next
position, keeping switch trigger depressed to
autofeed the next screw. (See page 7)
5
90°
C
D

Other manuals for RIDGID R6791

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RIDGID R6791 and is the answer not in the manual?

RIDGID R6791 Specifications

General IconGeneral
Chuck Size1/4 inch
Cordless / CordedCordless
Batteries IncludedYes
Chuck TypeHex
Battery TypeLithium-Ion

Related product manuals