2809
3
2.3 WORKING FIELD (as EN 267)
3. INSTALLATION
THE BURNER MUST BE INSTALLED IN CONFORMITY WITH LEGISLATION AND LOCAL STANDARDS.
3.1 MOUNTING THE BURNER
Fix the flange (1) to the boiler door using screw and nuts, interposing the insulating gasket (see fig. 2).
The insulating gasket has six holes, which, if necessary, can be modified as shown in the figure 3.
Verify that the installed burner is lightly leaned towards the button (see fig. 4).
The burner is designed to allow entry of the flexible oil-lines on either side of the burner.
Pressure in the combustion
chamber – mbar
Fuel output - kg/h
Thermal power - kW
0.8
0.2
0.4
0.6
510T1K 510T3K
0
1.2
D4361
1.4 1.6 1.8 2 2.2 2.4 2.6 2.8 3
16 18 20 22 24 26 28 30 32 34 36
S7386
Fig. 4
D5242
Fig. 3Fig. 2
1
D5574
To Next Page
Loading...
