3004
4
GB
3. INSTALLATION
THE BURNER MUST BE INSTALLED IN CONFORMITY WITH LEGISLATION AND LOCAL STANDARDS.
3.1 HEAT GENERATOR FIXING
y Put on the flange (1) the screw and two nuts, (see Fig. 3).
y Widen, if necessary, the insulating gasket holes (4).
y Fix the flange (1) to the heat generator door (3) using screws (5) and (if necessary) the nuts (2) inter-
posing the insulating gasket (4), (see Fig. 2).
y After installation ensure that burner is lightly inclined as in Fig. 4.
Fig. 4
D5025
Fig. 2
Fig. 3
S7071
3.2 WORKING POSITION
The burner is designed to work only in the po-
sitions 1, 2, 4 and 6.
Any other position could compromise the cor-
rect working of the appliance.
Installations 3 and 5 are forbidden for safety
reasons.
D4420
1 2 3
4 5 6
To Next Page
Loading...
