Riello Gulliver RG5DF - 3 Installation; Screw and Nuts for Flange to be Fixed to the Heat Generator; Working Position

2902
4
GB
3. INSTALLATION
THE BURNER MUST BE INSTALLED IN CONFORMITY WITH LEGISLATION AND LOCAL STANDARDS.
3.1 HEAT GENERATOR FIXING
➤ Put on the flange (1) the screw and two nuts, (see fig. 3).
➤ Widen, if necessary, the insulating gasket holes (4), (see fig. 4).
➤ Fix the flange (1) to the heat generator door (3) using screws (5) and (if necessary) the nuts (2) inter-
posing the insulating gasket (4), (see fig. 2).
➤ After installation ensure that burner is lightly inclined as in fig. 5.
3.2 WORKING POSITION
Fig. 5
D5012
Fig. 4
D5025
Fig. 2
Fig. 3
S7112
4
3
2
1
5
The burner is designed to work only in the po-
sitions 1, 2, 4 and 6.
Any other position could compromise the cor-
rect working of the appliance.
Installations 3 and 5 are forbidden for safety
reasons.
D4420
1 2 3
4 5 6