Riello NXHM 018 - 6.2 Additional Installation Precautions

57
Thewiringshouldadapttothewiredcontrollercurrent.
Otherwise,electricleakageorheatingmayoccurandresultinre.
Thespeciedcablesshallbeappliedinthewiring.Noexternalforcemaybeappliedtotheter-
minal.
Otherwise,wirecutandheatingmayoccurandresultinre.
Donotplacethewiredremotecontrollernearthelamps,toavoidtheremotesignalofthecontrol-
lertobedisturbed.(refertotherightgure)
6.2 Other Precautions
6.2.1 Installation location
Install the unit avoiding:
- locations near heat sources
- direct exposure to sunlight
-placeswithalotofoil,steamand/orsulphidegas.
Otherwise,theproductmaydeformandfail.
6.2.2 Preparation before installation
1)Checkwhetherthefollowingassembliesarecomplete.
No. Name. Qty Remarks
1 Wired Controller 1
2 Crossroundheadwoodmountingscrew 3 For Mounting on the Wall
3 Crossroundheadmountingscrew 2
For Mounting on the
ElectricalSwitchBox
4 InstallationandOwner'sManual 1
5 Plastic bolt 2
Thisaccessoryisusedwhen
install the centralized control
inside the electric cabinet
6 Plastic expansion pipe 3 For mounting on the Wall