Rievtech ELC Series - Page 15

1. Products Covered
The manual applies to devices of ELC and EXM series and
PR series. Our full range of xLogic Micro PLC’s.
Product Safety
This manual contains notices you have to observe to ensure
your personal safety, as well as to prevent damage to
property. The notices referring to your personal safety are
highlighted in the manual by a safety alert symbol; notices
referring to property damage only, have no safety alert
symbol. The notices shown below are graded according to
the degree of danger.
Table 1 - Safety Warnings
Symbol
Hazard Description
Indicates that death, severe personal
injury or damage to assets will result if
proper precautions are not taken.
Indicates that death, severe personal
injury or damage to assets may result if
proper precautions are not taken.
Indicates personal injury or damage to
assets can result if proper precautions
are not taken.
Indicates that an unintended result or
situation may occur if the corresponding
notice is not taken.
NOTICE:
If more than one warning is present, then the
warning with the highest degree of danger shall be used.
Qualified Personnel
Only persons qualified to correct electrical and safety
standards and regulations at the time of use should be
allowed to install, commission and operate this equipment.
The device/system may only be set up and used in
conjunction with this documentation. Commissioning and
operation of a device/system may only be performed by
qualified personnel. Within the context of the safety notices
in this documentation qualified persons are defined as
persons who are authorized to commission, ground and
label devices, systems and circuits in accordance with
established safety practices and standards. Please read the
complete operating instructions before installation and
commissioning. Rievtech or its distributors does not accept
any liability for possible damage to persons, buildings or
machines, which occur due to incorrect use or from not
following this manual.
Trademarks
All names identified by xLogic are registered trademarks of
the Rievtech. The remaining trademarks in this publication
may be trademarks whose use by third parties for their own
purposes could violate the rights of the owner.
Copyright Rievtech 2015 all rights
reserved
The distribution and duplication of this document or the
utilization and transmission of its contents are not
permitted without express written permission. Offenders
will be liable for damages. All rights, including rights
created by patent grant or registration of a utility model or
design, are reserved.
Disclaim of Liability
We have reviewed the contents of this publication to
ensure consistency with the hardware and software
described. Since variance cannot be precluded entirely, we