Need help?Do you have a question about the RIGIDBOT 2117 and is the answer not in the manual?
Lists and illustrates all parts required for Sub-Assembly 1.
Details the components needed for Sub Assembly 2.
Provides a list of parts and assembly steps for the extruder.
Shows the final assembled view of the extruder unit.
Details the components and assembly steps for the gantry.
Lists parts and instructions for assembling the top frame.
Provides parts and instructions for the bottom frame assembly.
Details the components and steps for the middle frame assembly.
Lists parts and instructions for combined bottom, middle, and gantry assembly.
Provides parts and assembly steps for the heated bed.
Final steps and parts for completing the overall frame assembly.
Details parts and instructions for optional add-on assemblies.
General| Filament Diameter | 1.75mm |
|---|---|
| Nozzle Diameter | 0.4mm |
| Connectivity | USB, SD Card |
| Heated Bed | Yes |
| Bed Temperature | Up to 100°C |
| Frame Material | Aluminum |
| Print Speed | Up to 100 mm/s |
| Supported Materials | PLA, ABS, PETG |
To Next Page
