RigMaster Power Service and Repair Manual
Document # S2110909
Copyright RigMaster Power by Mobile Thermo Systems Inc. 09-28-09
Figure 2-2 Figure 2-3
Procedure:
1. Remove the air filter canister from the intake manifold. (loosen the hose clamps at locations
A and B as shown in Figure 2-1)
2. Protect the air intake manifold from dirt or other debris that may enter the engine.
3. Remove top cover from the air filter canister.
4. Remove air filter element and clean the inside of air canister. Allow the air canister to dry
completely.
5. Replace air filter element. (use only manufacturer approved filters)
6. Reinstall the air canister lid. (Turn clockwise).
7. Reinstall the air filter canister assembly.
8. Tighten the hose clamps, and double check the lid is on properly.
Before test running the engine inspect the filter hoses for cracks or brittle sections.
Damaged or degraded hose should be replaced.
To Next Page
Loading...