Rigol DG800 Series - Coupling Commands

RIGOL Chapter 2 Command System
2-8 DG800 Programming Guide
:COUPling Commands
The :COUPling commands are used to set the related information of the channel frequency coupling,
amplitude coupling, and phase coupling; enable and disable the three coupling functions.
Command List:
 :COUPling[<n>]:AMPL:DEViation
 :COUPling[<n>]:AMPL:MODE
 :COUPling[<n>]:AMPL:RATio
 :COUPling[<n>]:AMPL[:STATe]
 :COUPling[<n>]:FREQuency:DEViation
 :COUPling[<n>]:FREQuency:MODE
 :COUPling[<n>]:FREQuency:RATio
 :COUPling[<n>]:FREQuency[:STATe]
 :COUPling[<n>]:PHASe:DEViation
 :COUPling[<n>]:PHASe:MODE
 :COUPling[<n>]:PHASe:RATio
 :COUPling[<n>]:PHASe[:STATe]
 :COUPling[<n>][:STATe]
 :COUPling[<n>]:TRIgger[:STATe]
Note: The coupling function is only available when both the waveforms of the two channels are basic
waveforms (Sine, Square, Ramp, or Arbitrary waveform).