Rigol DG812 - Page 41

Appendix RIGOL
DG800 Performance Verification Guide
9
10 MHz: <-105 dBc/Hz
Signal Characteristics
Square
Rise/Fall Time
Typical (1 Vpp, 1 kHz)
≤9 ns
Overshoot
Typical (100 kHz, 1 Vpp)
≤5%
Duty
0.01% to 99.99% (limited by the current frequency setting)
Non-symmetry
1% of the period + 4 ns
Jitter (rms)
Typical (1 Vpp)
≤5 MHz: 2 ppm of the period + 200 ps
>5 MHz: 200 ps
Ramp
Linearity
≤1% of peak output (typical, 1 kHz, 1 VPP, 100% symmetry)
Symmetry
0% to 100%
Pulse
Pulse
16 ns to 1000 ks (limited by the current frequency setting)
Duty
0.001% to 99.999% (limited by the current frequency setting)
Rising/Falling Edge
≥8 ns (limited by the current frequency setting and pulse width setting)
Overshoot
Typical (1 Vpp, 1 kHz)
≤5%
Jitter (rms)
Typical (1 Vpp)
≤5 MHz: 2 ppm of the period + 200 ps
>5 MHz: 200 ps
Arbitrary Waveform Sequence
Waveform Length
2 Mpts (optional 8 Mpts)
Vertical Resolution
16 bits
Sample Rate
Interpolation filter: 10 Sa/s to 30 MSa/s
Step filter: 2k Sa/s to 30 MSa/s
Smooth filter: 2k Sa/s to 30 MSa/s
Min Rise/Fall Time
Interpolation filter: ≥8 ns
Step filter: 3.0/sample rate
Smooth filter: 1.0/sample rate
Jitter (rms)
Typical (1 Vpp)
Interpolation filter: 200 ps
Step filter: <5 ps
Smooth filter: <5 ps
Overshoot
Typical (1 Vpp)
≤5%
Harmonic Output
Harmonic Order
≤8
Harmonic Type
Even Harmonic, Odd Harmonic, Order Harmonic, User
Harmonic
Amplitude
The amplitude of each order of the harmonic can be set.
Harmonic Phase
The phase of each order of harmonic can be set.
Output Characteristics
Amplitude (into 50 Ω)
Range
≤10 MHz: 1.0 mVpp to 10 Vpp
≤30 MHz: 1.0 mVpp to 5.0 Vpp
≤35 MHz: 1.0 mVpp to 2.5 Vpp