To Next PageTo Next PageHow to fix noisy operation in Rikon Power Tools Power Tool?
Noisy operation in your Rikon Power Tools Power Tool can stem from several causes. Here's what you should check: * Incorrect belt tension: Adjust the tension. * Dry Spindle: Lubricate the spindle. * Loose spindle pulley: Check the tightness of the retaining nut on the pulley and tighten if necessary. * Loose motor pulley: Tighten the set screws in the pulleys.
Why drill bit burns material with Rikon Power Tools Power Tool?
If your drill bit is burning the material while using your Rikon Power Tools Power Tool, consider these possible causes and solutions: * Incorrect speed: Change the speed. * Chips not coming out of hole: Retract the drill bit frequently to clear chips. * Dull drill bit: Resharpen the drill bit. * Feeding too slow: Increase the speed. * Not Lubricated: Lubricate the drill bit.
What to do if excessive drill bit runout or wobble in Rikon Power Tools Power Tool?
Excessive drill bit runout or wobble in your Rikon Power Tools Power Tool could be due to: * Bent drill bit: Use a straight drill bit. * Worn spindle bearings: Replace the bearings. * Drill bit not properly installed in chuck: Install the drill bit properly. * Chuck not properly installed: Install the chuck properly.
How to stop drill bit binding in workpiece with Rikon Power Tools Power Tool?
If the drill bit binds in the workpiece when using your Rikon Power Tools Power Tool, it could be due to: * Workpiece pinching the drill bit or excessive feed pressure: Support the workpiece or clamp it. * Improper belt tension: Adjust the belt tension.
Why drill bit leads off and hole not round with Rikon Power Tools Power Tool?
If the drill bit leads off and the hole isn't round when using your Rikon Power Tools Power Tool, it might be because: * Hard grain in wood or lengths of cutting lips and/ or angles not equal: Resharpen the drill bit correctly. * Bent drill bit: Replace the drill bit.
What to do if wood piece pulled loose from hands using Rikon Power Tools Power Tool?
If a wood piece is pulled loose from your hands while using the Rikon Power Tools Power Tool, it is likely because it was not supported or clamped properly. To resolve this, support the workpiece or clamp it securely.
How to prevent wood splinters on underside of workpiece with Rikon Power Tools Power Tool?
To prevent wood splinters on the underside of your workpiece when using the Rikon Power Tools Power Tool, use "back-up material" under the workpiece.
Why quill returns too slow or too fast on Rikon Power Tools Power Tool?
If the quill returns too slowly or too quickly on your Rikon Power Tools Power Tool, the spring likely has improper tension. Adjust the spring tension to correct this.
Why chuck will not stay attached to spindle on Rikon Power Tools Power Tool?
If the chuck will not stay attached to the spindle and falls off when you try to install it on your Rikon Power Tools Power Tool, it is probably because there is dirt, grease, or oil on the tapered inside surface of the chuck or on the spindle's tapered surface. Using a household detergent, clean the tapered surfaces of both the chuck and spindle to remove all dirt, grease, and oil.
General| Model | 30-120 |
|---|---|
| Type | Drill Press |
| Motor | 1/2 HP |
| Spindle Travel | 3-1/8 inches |
| Voltage | 120V |
| Swing | 13 in |
| Spindle Speed | 250 - 3, 050 RPM |
