Need help?Do you have a question about the Riley PATHFINDER and is the answer not in the manual?
General| Brand | Riley |
|---|---|
| Model | PATHFINDER |
| Category | Automobile |
| Language | English |
Details on fuel tank level, delivery, pump test, carburetters, and needles.
Information on clutch type, facing, and springs.
Details on synchromesh, overdrive, and ratios.
Specifications for camber, castor, toe-in, swivel pin inclination, steering ratio, wheel diameter, and turning circle.
Details on rear axle type, drive, adjustment, ratio, and overall ratios.
Information on front and rear spring types, deflection, and specifications.
Details on wheel size, tyre size, and tyre pressures.
Information on brake type, lining, and lining area.
Details on system voltage, distributor rotation, advance, firing point, contact breaker gap, sparking plugs, battery, and starter drive ratio.
Lists capacities for sump, gearbox, overdrive, rear axle, fuel tank, cooling system, and luggage boot.
Width, length, height, wheelbase, track, ground clearance, turning circle, frontal area, and weight.
Torque values for cylinder head, connecting rod, main bearing, flywheel, rocker-shaft nuts, pinion bearing, differential caps, crown wheel bolts, and pinion bearing pre-load.
Identifies and describes the function of various dashboard instruments.
Explains the operation of Mixture Control and Ignition Switch.
Describes the function and operation of various controls like starter, throttle, ignition, lamps, lighter, wipers, washer, heater, and radio.
Instructions for filling, draining, and checking the cooling system.
Location of the tool kit within the vehicle.
Instructions on how to safely jack up the vehicle using jacking brackets.
Instructions on how to access and secure the spare wheel.
Information on where to find car and engine numbers for communication.
Contact addresses and telegram details for home and overseas enquiries.
Explains how to identify unified screw threads on nuts, bolts, and set screws.
Explains the meaning of symbols on the identification plate for vehicle details and paint finish.
List of checks and adjustments for the initial service period.
Tasks for every 1,000 miles, plus intervals for 3,000, 6,000, and 12,000 miles.
To Next Page
