Rimage 2000i Alignment Guide

Rimage 2000i Operator
2000557_C © 2009, Rimage Corporation 1
Align a Recorder
Use this procedure to align a recorder in a Rimage 2000i.
Rimage approved parts must be used for this process. The product warranty may become void if parts not approved by Rimage are
used; equipment or parts are tampered with, misused, neglected, or modified in any respect without the written consent of Rimage.
n Caution! Some cables in this system are latched. Equipment damage may occur if cables are not disconnected appropriately.
 Note: Your system may not look exactly like the system pictured.
Before you begin
1. Stop or pause all jobs.
2. Power off the Rimage 2000i.
3. Disconnect the power cord from the power outlet.
# Required tools:
• T10 Torx screwdriver
• 5/64″ Allen wrench
Prepare the System
1. If the cables are still connected at the back of the
Rimage 2000i, disconnect the cables.
• FireWire cable (if present)
• USB cable
• Power cord
2. Remove the back panel.
a. Remove the Torx T10 screws (Qty. 6) that
secure the back panel.
b. While firmly grasping the top of the back
panel, lift and pull back to remove it.
3. Remove the left and right side panels (Qty. 2) by
sliding them straight back and off the system.
Power
Cord
USB Cable
FireWire Cable
(if present)
Back Panel
Left Side Panel
Right Side Panel

Rimage 2000i Specifications

General

Model	Rimage 2000i
Type	Disc Duplicator
Number of Drives	2
Interface	USB 2.0
Disc Capacity	100 discs
Print Resolution	300 dpi
Supported Media	CD-R, CD-RW, DVD-R, DVD+R, DVD-RW, DVD+RW, DVD-R DL, DVD+R DL
Print Technology	Thermal Transfer
Disc Formats Supported	CD
Operating System Compatibility	Windows XP, Windows Vista, Windows 7