8
8
SmartCharge
7
Operation - Battery Analysing
Battery Capacity
Measures the cranking performance of the battery to determine engine starting ability and battery performance.
1.
+
2.
+ CCA or EN +
Set the battery standard CCA or EN***
3.
+ CCA/EN value +
Input the battery CCA or EN value ***
*** markings on a battery will state the battery standard and value
If CCA or EN values not stated, select CCA and use the following table
CCA
1000-1299cc 300 CCA
1300-1599cc 400 CCA
1600-1999cc 500 CCA
2000-2999cc 700 CCA
3000-3500cc 800 CCA
4.
Actual battery value is displayed plus capacity %
Good, check or bad status displayed
Good >74 %, check 50-74% and bad <50%
This function will not operate if the battery voltage is less than 8v
Operation - Memory Saver
Memory Saver
The memory saver function allows the vehicle electrical and audio settings to be retained when the battery is removed.
1.
Connect the SmartCharge battery clips to positive (+) and negative (-) cables on the vehicle that attached to
the battery terminals
2.
With the AC mains power connected press the Auto Charge button for 5 seconds. Memory Saver mode is
activated when MEM is displayed on the LCD display
3.
Remove the vehicle battery
4.
Ensure the vehicle battery is connected correctly before disengaging the SmartCharger to ensure no loss of
vehicle / audio settings
5 Seconds
• 8272 RING SmartCharge RSC608 RESC608 Instructions Book.indb 8 27/10/2014 14:36
To Next Page
Loading...
Need help?
General
