Technical parameters
Toilet lid - remote control communication connection
●Functional operation can be performed after successful communication between the toilet lid and the
remote controller;
● This product has been set up with a communication connection at the factory, which can be used by no
setting;
If the remote control communication connection
status is blocked, or after replacing the new
remote control, you need to set it again before
you can use it.
Remote control setting method (toilet remote control
communication connection)
1.After plugging in the power, put the palm on the seat skin sensor within
3 sec o nd s. After the in duc ti o n, en su re the pa lm l e av e th e sea t
immediately, and the toilet lid will make a “di” sound;
2.Press and hold “Stop” and “Hip Cleaning” buttons for more than 3
seconds. (Water pressure, warm air and LED lights will be turned off for
five times) After the communication connection is completed, the remote
control can be used.
To Next Page