EasyManuals Logo

Rinnai EHPS265VM User Manual

Rinnai EHPS265VM
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4 |
Important information
WARNING
Installation and service to be carried out by a licensed tradesperson.
DO NOT operate this system before reading the operation and installation information.
DO NOT place articles on or against this appliance.
DO NOT store chemicals or ammable materials near this appliance.
DO NOT operate with panels or covers removed from this appliance.
DO NOT activate heating elements unless full of water.
For safe operation this water heater is tted with:
A combination Temperature & Pressure Relief (TPR) Valve.
One thermostat and one over-temperature control for each heating element.
Operation of the over-temperature cut-out indicates a possibly dangerous situation. It must only be
reset by an authorised person after the appliance has been inspected and serviced as required.
DO NOT tamper or remove any of the safety devices noted above.
DO NOT operate this water heater unless all these devices are tted and in working order.
TEMPERATURE AND PRESSURE RELIEF (TPR) VALVE
A TPR valve must be tted. It must be installed in accordance with these instructions.
WARNING
The valve and drain pipe must never be sealed or blocked.
DO NOT supply heat to any ttings when making connections. Ensure all pipes are clean and
free from any foreign matter before making connections. Check water leaks at all joints. Damage
caused by leaking joints is not covered by warranty.
DO NOT build this appliance in such a way that it can not be easily serviced or replaced. Additional
cost incurred by such installations is not covered by warranty.
MAKE SURE the cylinder is full of water before energising the system. Failing to do so can cause
irreparable damage to the element and sensors.
UNIT HANDLING move and position the unit using the two handholds provided on either side of
the cylinder section of the system.
R290 REFRIGERANT
This appliance uses R290 (propane) refrigerant, which is a ammable gas according to
AS/NZS 5149 and MUST be handled by a refrigeration mechanic with an appropriate refrigerant
handling license.
AS/NZS 60335.2.40
WARNING
Do not use means to accelerate the defrosting process or to clean, other than those
recommended by the manufacturer.
The appliance must be installed as specied in this installation guide, without continuously
operating ignition sources in the vicinity.
Do not pierce or burn.
Be aware that refrigerants may not contain an odour.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rinnai EHPS265VM and is the answer not in the manual?

Rinnai EHPS265VM Specifications

General IconGeneral
BrandRinnai
ModelEHPS265VM
CategoryHeat Pump
LanguageEnglish

Related product manuals