Rinnai RPB200 - User Manual

100000862 10/2023
❶
Thank you for purchasing a Rinnai RPB200 Recirculaon Push Buon! Please read the instrucons below
for installaon and operang instrucons.
VERIFY COMPATIBILITY
Ensure you have a compable Rinnai product
(wireless module, tankless water heater, boiler,
etc.) before installing this buon. If you are unsure,
scan the QR code at the end of this guide for a
complete list of compable products.
❷ PAIR: Pair the push buon to your Rinnai product:
• Water Heaters/Boilers: Press and hold the Bluetooth
buon on the controller unl the Bluetooth LED
starts ashing. Then, release the buon.
RWM200 Wireless Module: Press and hold the
“Connect” buon on the module unl the top LED
light starts ashing green. Then, release the buon.
• Press and hold the push buon unl the LED on the
push buon ashes GREEN.
Having trouble? Scan the QR code at the end of this
guide for detailed pairing instrucons.
To unpair the push buon from one Rinnai product and
pair to a dierent Rinnai product, repeat the above
pairing process with the new Rinnai product.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION. FCC ID: 2ACR9-FLIC2
IC: 12180a-FLIC2
ATTACH PUSH BUTTON TO A SURFACE
1. Pair the push buon and verify operaon in the
desired locaon prior to aaching the buon to
a surface.
2. Clean and dry the surface area.
3. Remove the paper on the back of the push
buon to expose the adhesive.
4. Aach the push buon to the desired locaon.
NOTE: To remove the push buon, gently pull the
push buon from the surface. Gently clean the
adhesive on the back of the push buon with a
damp cloth if needed before aaching the push
buon to a new surface.
❹

REPLACE BATTERY (WHEN NEEDED)
1. Twist the push buon counter-clockwise
to expose the baery.
2. Gently remove the baery and replace with a
new CR2023 baery.
3. Twist the push buon back onto the buon back
clockwise.
❺
OPERATE:
Press the push buon to acvate the Rinnai product’s
recirculaon system. The recirculaon system
deacvates aer ve minutes from the last acvaon
or when the water has reached the set temperature.
NOTE: If the recirculang pump has recently been
acve and the recirculaon loop is sll warm, there
may be a delay in pump acvaon. To minimize any
delay in pump acvaon, set the Rinnai product to
Comfort Mode (refer to the “Recirculaon Mode”
secon in the Rinnai product Installaon and Operaon
Manual for more informaon on Comfort Mode).
Push Buon LED Indicator Lights:
• FLASHING RED: Push buon is not yet paired.
• FLASHING YELLOW: Push buon is aempng to
connect to the paired Rinnai product.
• FLASHING GREEN: Push buon has successfully
paired and requested recirculaon.
❸
Quesons? Call Rinnai at 1-800-621-9419
Scan the code for
detailed push buon
installaon and
operang instrucons.

Rinnai RPB200 Specifications