EasyManua.ls Logo

Rion GH40 - Safety First; Concrete Foundation

Rion GH40
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
Safety First
Check the contents of the greenhouse packaging against the packing list and the required parts for your
model on page 4 and following. Do not begin assembly if any parts are missing.
Please read these Assembly Instructions completely before assembly and keep them in your records so you
can refer to them if you wish to add options or make repairs.
The instructions in this manual lead you through each step in the assembly process. It is important for you to
follow them closely.
We recommend that you use gloves during assembly.
Rion is not responsible for the misuse of tools or parts.
If local building codes require permits or licenses make sure that they are acquired before beginning.
Your Greenhouse should be securely anchored to the prepared foundation or the Modular Base (available as
an option) using the recommended hardware.
If you prepare a concrete foundation do not excavate and pour concrete in frozen ground.
Exercise caution when lifting heavy assemblies.
Do not attempt to assemble your Greenhouse in high winds.
We recommend that you place your Greenhouse in a spot where it will receive direct sunlight and will be
protected from the wind as much as possible. The door should not face prevailing winds.
When your Greenhouse is fully assembled examine it for sharp edges and trim with a razor knife if
necessary.
Close all roof vents in high winds.
It is important to clear your Greenhouse of snow in the winter.
Make sure that the temperature in the greenhouse never exceeds 70° C (155° F). Ensure good ventilation
during hot days or provide a shading screen. This is especially important if you live in a hot climate.
Required Tools
Before you start assembly have the following available:
Measuring tape
•Spirit level
Scissors
•Gloves
•Razor knife
Note: You may find some parts easier to assemble if you first moisten them with soapy water.
Concrete Foundation
70 mm x 6 mm (2C" x B") screws and concrete anchor set or expansion anchor. (See quantities on
page 3.)
•Hammer
Power drill and appropriate masonry bit
Screwdriver for screws or wrench for expansion anchors. A power tool with the appropriate bit is
recommended.
Note: If you have purchased a Modular Base all hardware is included.
Accessories
Your Greenhouse comes with two roof vents. Additional roof vents (Part WIN33AC) are available as an
option.
A Modular Base can be purchased for your Greenhouse’s foundation.

Related product manuals