11
• Repack the wheel hubs after the first 500 kilometres of travel ; then yearly thereafter.
• Visually inspect the wheel bolts for tightness each day. Torque to 110 ft lbs. (149 Nm) after the first
few hours of operation and frequently thereafter.
• Ensure the tires are inflated to the correct pressure:
12.5L-15 : 90 psi
380/55 R16.5 : 70 psi
235/75 R17.5 : 125 psi
• Grease all pins and knuckles. (See decals locations)
• Grease harrow chain bearings.
• Visually inspect hydraulic hoses & fittings for leaks or damage.
• Inspect wheel bearings / hubs for tightness and grease.
• Check wheel bolts for tightness and re-torque.
• Visually inspect unit for loose, worn or damaged components.
• Coat any exposed cylinder shafts with thick oil or grease.
• Ensure that parking jacks are situated on firm ground. Failure to do so may cause the hitch to rise
sharply as the jack pads sink into the ground.
• Lock all applicable safety pins into place.
NOTE: All fasteners with locknuts that are used to join moving pieces should not be
tightened completely to allow for movement.
To Next Page
Loading...