27
A. Identify the size of your LAND ROLLER
B. Confirm the draft arm length. This length is measured from center to center of the ball joint holes.
C. Measure from the end of the wing (end closest to center frame) and make a mark on the wing at
the indicated measurement. On a F3 & F5, the measurement applies to the outermost wing. On a
F7, the measurement applies to the middle wing.
D. Install the draft arm clevis plate with the leading edge at the mark. This may require flipping the
plate around. The clevis hole number is as shown:
E. Some installations have the clevis plate surrounding a wing cross member. This is a final double
check that the clevis is properly installed.
To Next Page
Loading...