Need help?Do you have a question about the Rittal 8617.502 and is the answer not in the manual?
This document describes the Rittal VX Baying Connector, external, designed for joining Rittal VX series enclosures. The product numbers covered are 8617.502 and 8617.503.
The Rittal VX Baying Connector, external, serves to securely connect two Rittal VX series enclosures side-by-side. This external baying connector ensures a stable and robust connection between enclosures, which is crucial for creating larger, integrated enclosure systems. The baying process involves attaching the connectors to the exterior of the enclosures, providing structural integrity and alignment. The system is designed to facilitate the creation of modular enclosure setups, allowing for flexible expansion and configuration of industrial and IT infrastructure.
The baying connectors are available in two main variants, corresponding to different material types and potentially different applications:
Both variants include the following components in their scope of delivery:
The tightening torque for the mounting screws is specified as MA = 5 Nm.
Approvals and Certifications:
These approvals indicate compliance with specific safety and performance standards for enclosure accessories, including environmental protection ratings (e.g., NEMA types). The "Type 1, 12" rating for the sheet steel variant suggests suitability for indoor use, providing protection against dust, dirt, and light splashing. The "Type 1, 3R, 4, 4X, 12" rating for the stainless steel variant indicates a higher level of protection, including resistance to rain, sleet, external ice formation, and corrosion (due to the "4X" rating for stainless steel), making it suitable for both indoor and outdoor applications in more demanding environments.
The product is exclusively designed for use with Rittal VX series products.
The installation process for the baying connectors is detailed in the assembly instructions and involves several key steps:
General Baying (for all widths/depths):
Specific Baying for Width/Depth > 800 mm: For larger enclosures (width/depth > 800 mm), the baying process requires additional attention to ensure proper sealing and structural integrity. The general steps of mounting the baying connectors and applying the seal remain the same, but the larger dimensions might necessitate careful handling of the seal to avoid tension. The instructions emphasize the importance of not subjecting the baying seal to tensile forces during installation, especially for these larger dimensions.
Crane Transport Considerations (TX30 series): If the bayed enclosures are part of the TX30 series and are to be transported by crane, a "combination angle" (Kombiwinkel) must be used. This additional component is essential for safe crane transport and its specific usage details can be found in the separate "load capacity brochure" (Belastungsbroschüre). This highlights the importance of consulting supplementary documentation for specific application scenarios, particularly those involving heavy lifting.
NEMA 4 Compliance: For applications requiring NEMA 4 compliance, specific instructions (2.1 NEMA 4 and 2.2 NEMA 4) must be followed. These instructions likely detail specific sealing methods or additional components required to achieve the NEMA 4 rating, which ensures protection against windblown dust, rain, splashing water, hose-directed water, and external ice formation.
While the document does not explicitly detail maintenance features, the design of the baying connector system implies certain aspects:
General| Brand | Rittal |
|---|---|
| Model | 8617.502 |
| Category | Cables and connectors |
| Language | English |
To Next Page