Rivacold BLOCKSYSTEM FA - Page 87

BLOCKSYSTEM FA-FT Pag. 87 REV. 04 10/07
DECLARATION OF CONFORMITY
In conformity with the VII enclosure of 97/23 CE directive
Manufacturer: RIVACOLD S.r.l.
Address: Via Sicilia 7, 61020 Montecchio (PU), Italy.
Hereby Rivacold s.r.l. states that the refrigerating unit (FA-FT)as described hereby
conforms with 97/23 CE directive and has undergone the conformity evaluation procedure as follows:
 Cat 0 is excluded according to article 3.3
 Cat I Module A (internal manufacturing control)
 Cat II Module A1 (internal manufacturing control and final test control), TÜV notified body Süddeutschland
Bau und Betrieb gmbh(0036)
It also conforms with the following directives:
98 / 37 CE Machine Directive
89 / 336 CEE Electro-magnetic Compatibility
73 / 23 CEE Low Tension
And has been manufactured by following standards:
EN 60 204- 1 Machinery safety – Machine electrical equipment
CEI EN 60335-1 Electrical device safety
CEI EN 60335-1-24 Electrical device safety
UNI EN 12100 – 1;UNI EN 12100 - 2 Machinery safety
EN 378 – 1;prEN 378 – 2
Refrigerating equipment and heat pumps – safety and
environmental requirements
Description of pressure components that may be part of the complete units conformity evaluation procedures in use:
Description Evaluation procedure
art.3.3 CAT I CAT II CAT III CAT IV
Compressor Module A Module D1 - -
Liquid receiver Module A Module D1 Module B1+D Module B+D
Pressure relief valve
- -
Module
G/B+D
Safety pressure switch - - Module B+D
Oil separator / Oil
reserve
Module A Module D1/A1 Module B1+D -
Liquid separator Module A Module D1/A1 - -
Plate-type heat
exchanger
Module B+D
Cartridge filters Module A Module D1 - -
Manifolds DN≤35mm Module A Module A1 Module B+C1
Piping DN≤35mm 35≤DN≤108
The category of the assembly “shall be determined by the highest category applicable to the equipment concerned
other than that applicable to any safety accessories” 97/23 EC art. 10 §2.b
Managing Director
Rev. 16 Alceste Vitri