12
DISCONNECT THE HIGH VOLTAGE BY CUTTING A CUT LOOP
There are two cut loop locations in the vehicle. The cut loops are low-voltage circuits that enable power from
the high-voltage battery and supplementary restraint system (SRS). Cutting either loop disconnects both the high
voltage battery and the SRS systems within one (1) minute.
The primary cut loop is located under the hood. Asecondary cut loop is located in the vertical post behind the
passenger-side rear window (C pillar). Use the secondary cut loop only if the primary cut loop is inaccessible.
DISCONNECT HIGH-VOLTAGE — FRONT
Rivian recommends you use the following tools (high-voltage insulated) to disconnect the high-voltage system by
cutting the low-voltage cable at the front of the vehicle:
l insulated gloves
l personal protective equipment
l insulated cable cutter
DISCONNECTTHEHIGHVOLTAGE
To Next Page
Loading...
Need help?
General
