Headlight High-Low Beam
To
change the headlights
from low beam to high or
high to low, pull the turn
signal lever all the way
toward
you.
Then release it.
When the high beams are
on, a blue light on the
instrument panel also will
be on.
If
your headlights are on, but
on
low beam: The system
works normally. Just pull the lever until it clicks. Your
headlights will shift to high beam and stay there. To
return to low beam, just pull the lever toward you.
Windshield Wipers
Flash-To-Pass Feature
This feature lets you use your high beam headlights to
signal a driver in front of you that
you
want to pass. It
works even if your headlights are
off.
To use it, pull the headlight beam toward
you
a little
(but not
so
far that you hear a click). When you do:
If
your headlights are
off
Your high beam headlights
will
turn
on. They’ll stay on as long as you hold the
lever there. Release the lever to turn them
off.
.
.
. .
~
You
control the windshield wipers by turning the band
marked “WIPER.”
For a single wiping cycle, turn the band to
“MIST.”
Hold it there until the wipers
start,
then let go. The
wipers will stop after one cycle. If
you
want more
cycles, hold the band on
“MIST”
longer.
87
To Next Page
Loading...