Basic Preset Programming
Each preset in the Mastermind PBC/6X can turn on loops, set loop order and select amp channel, all with the press of one button.
To program a preset:
1. Select a preset using the Preset and Bank page
2. Press FUNCTION to change to the Loops page
3. Use the L1 through L6 buttons to turn on or off the desired pedal loops
4. Press FUNCTION to change to the Switches page
5. If needed, use the buttons to turn on or off the other functions (function switches, insert loop, input buffer, input and output)
6. Hold the FUNCTION button for 3 seconds, until the “Stored” message appears
7. Press FUNCTION to return to the Preset and Bank page
Repeat these steps for each preset you wish to program.
Editing Preset Name and Loop Order
You can name presets and change loop order for each preset using the PBC’s setup mode. To enter setup mode, hold the 1 and 3
buttons for 3 seconds. The screen will change to the setup menu.
In this mode, the buttons perform the function printed on the left side of each button:
Up Arrow and Down Arrow move up and down through the list
SELECT selects an item
VAL+ and VAL- increase or decrease the currently selected value
EXIT returns to the previous menu
To edit a preset’s name:
In this screen, the buttons work differently:
Up Arrow and Down Arrow move the cursor left and right
VAL+ and VAL- changes the character under the cursor
BANK UP deletes the character to the left of the cursor
SELECT saves the new name and exits
EXIT leaves name editing without saving
To edit loop order:
Use this screen to adjust the loop order for this preset:
Up Arrow and Down Arrow move the cursor left and right
VAL+ and VAL- move the selected loop right or left
SELECT or EXIT saves changes and exits
To Previous Page
Loading...
Need help?
General
